Kern Electronics & Lasers KER52100-100G
Inquire- Manufactured by:
- Kern Electronics & Lasers
- Model number:
- KER52100-100G
- Year manufactured:
- 2003
- Condition:
-
Very good condition
- Asking price:
- $19,500
- Price when new:
- $84,000
- Hours of Use or Pulse Count:
- 700-900 total since 03/2003
- Included extras:
- Manual
Warranty
Demonstratable
Training
Installation - Parts and accessories:
- INCLUDES: CAD/CAM controller // Kern Laser monitor // Heat Exchanger // 2-1hp blowers (Grizzly) // 2.5 and 1.5 focal lenses // Kern DSP interface // unused backup stepper motor.
- Equipment location:
- New Jersey
- Additional information:
- THIS SYSTEM DOES BOTH ENGRAVING AND CUTTING. // This system has never been used commercially. Price includes repair of the RF supply. The RF supply was positioned on the floor and was flooded by Hurricane Sandy. All other parts were above the water line. This system was purchased new from Kern Lasers, Wadena, MN, in 2003 and has very low hours of use. Being sold where-is-as-is but installation included at extra cost.
- System Hours of Operation (hours):
- est. 700-900hrs total
- Laser Manufacturer:
- Kern
- Laser Model Number:
- KER 52100-1006
- Laser Date of Manufacture:
- 2002
- Laser Rated Power (watts):
- 100
- Laser Actual Power (watts):
- 125 when last measured
- Laser Hours of Operation (hours):
- est. 700-900hrs total
- Laser Cooling:
- water
- System XYZ Travel (inches or ):
- XY 50" x 100" inch in XY; 3.25 inch clearance Z
- System Controller & Software:
- Kern CAD/CAM controller
- System Input Power I:
- 220 VAC single phase
- Cutting Software:
- Kcam 6 cutting and engraving software
- Item Number:
- 5868
